Rear Left Sensor
Air Bag Sensor Rear LH:
REPLACEMENT
1. PRECAUTION
Observe Air Bag Systems; Service Precautions.
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE TONNEAU COVER RETRACTOR SUB-ASSEMBLY
4. REMOVE DECK BOARD ASSEMBLY
5. REMOVE REAR FLOOR MAT SUPPORT PLATE REAR
6. REMOVE DECK FLOOR BOX LH
8. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
9. REMOVE LAP BELT OUTER ANCHOR COVER REAR NO.1 SEAT
10. REMOVE DECK TRIM SIDE BOARD UPR LH
11. REMOVE DECK SIDE TRIM COVER LH
12. REMOVE AIR BAG SENSOR REAR LH
a. Disconnect the connector of the airbag sensor rear LH.
b. Remove the 2 nuts and the airbag sensor rear LH.
13. INSTALL AIR BAG SENSOR REAR LH
a. Install the airbag sensor rear LH with the 2 nuts.
Torque: 17.5 N.m (178 kgf.cm, 13 ft.lbf)
b. Connect the connector of the airbag sensor rear LH.
NOTE:
- Installation of the connector is done with the sensor assembly installed. Make sure the sensor assembly is installed with the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installation, shake the sensor assembly to check that there is no looseness.
14. INSPECT AIR BAG SENSOR REAR LH
15. INSPECT SRS WARNING LIGHT