With Manufacturer's Scan Tool

CHECK DIAGNOSIS

Using the hand-held tester, check for DTC.

NOTE: Hand-held tester only:
When the diagnosis system is changed from normal mode to check mode, all DTCs and freeze frame data recorded in normal mode will be erased. Before changing modes, always check the DTCs and freeze frame data, and make a note of them.

1. Prepare the hand-held tester.
2. Connect the hand-held tester to the DLC3 under the instrument panel lower pad.
3. Turn the ignition switch ON and push the hand-held tester switch ON.
4. Use the hand-held tester to check for DTCs and freeze frame data, and make a note of them (for operating instructions, see the hand-held tester instruction book).
5. Confirm the details of the DTCs.