Pinout Values and Diagnostic Parameters
TERMINALS OF ECUTerminals Of Control Module:
1. INSPECT SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
a. Disconnect the sliding roof ECU connector, and check the voltage or continuity of each terminal of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness.
Terminals Of Control Module - Check Overhead J/B:
2. CHECK OVERHEAD J/B
a. Disconnect the overhead J/B connector, and check the voltage or continuity of each terminal of the connector.
If the result is not as specified, there may be a malfunction on the wire harness.