Timing Cover: Service and Repair
TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEALREPLACEMENT
1. REMOVE FRONT WHEEL RH
2. REMOVE FRONT FENDER SPLASH SHIELD FRONT RH
3. REMOVE FRONT FENDER APRON SEAL RH
4. REMOVE ENGINE COVER SUB-ASSEMBLY NO.1
5. REMOVE ENGINE MOUNTING STAY NO.2 RH
6. REMOVE ENGINE MOVING CONTROL ROD W/BRACKET
7. REMOVE ENGINE MOUNTING STAY NO.2 RH
8. REMOVE ENGINE MOUNTING BRACKET NO.2 RH
9. REMOVE FAN AND GENERATOR V BELT
10. REMOVE CRANKSHAFT PULLEY
11. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL
a. Using SST, remove the oil seal.
SST 09308-10010, 09950-60010 (09951-00200)
12. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL
a. Apply MP grease to a new oil seal lip.
NOTICE: Keep the lip free from a foreign matter.
b. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
SST 09223-22010
NOTICE: Wipe off extra grease from the crankshaft.
13. INSTALL CRANKSHAFT PULLEY
14. INSTALL FAN AND GENERATOR V BELT
Torque: 52 Nm (531 kgf-cm, 38 ft. lbs.)
15. INSTALL ENGINE MOUNTING BRACKET NO.2 RH
Torque: 52 Nm (531 kgf-cm, 38 ft. lbs.)
16. INSTALL ENGINE MOUNTING STAY NO.2 RH
Torque: 64 Nm (653 kgf-cm, 47 ft. lbs.)
17. INSTALL ENGINE MOVING CONTROL ROD W/BRACKET
18. INSTALL FRONT WHEEL RH
19. CHECK FOR ENGINE OIL LEAKS