Cooler Compressor to Crankshaft Pulley V Belt

REPLACEMENT




1. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
a. Loosen bolt A.
b. Loosen bolt B.
c. Loosen bolt C and remove the V belt.




2. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
a. Temporarily install the V belt as illustrated.




3. ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
a. Apply drive belt tension by turning bolt C.

Drive belt tension:
New belt:160 to 180 lbf
Used belt:115 to 135 lbf




NOTE:
- "New V belt" refers to a belt which has been used for less than 5 minutes on a running engine.
- "Used V belt" refers to a belt which has been used for 5 minutes or more on a running engine.
- After installing the V belt, check that it fits properly in the ribbed grooves.




4. FULLY TIGHTEN V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
a. Tighten bolt A.

Torque: 58 N.m (591 kgf.cm, 43 ft.lbf)

b. Tighten bolt B.

Torque: 18 N.m (183 kgf.cm, 13 ft.lbf)