Operation CHARM: Car repair manuals for everyone.

Replacement

Airbag Sensor Front LH:






AIRBAG SENSOR FRONT LH

REPLACEMENT

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Installation is in the reverse order of removal.

1. OBSERVE RESTRAINT SYSTEMS SERVICE PRECAUTIONS
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE FRONT BUMPER COVER
4. REMOVE RADIATOR GRILLE
5. REMOVE LH HEADLAMP ASSEMBLY




6. REMOVE AIRBAG SENSOR FRONT LH
a. Disconnect the connector from the airbag sensor front LH.
b. Remove the 2 bolts and the airbag sensor front LH.

7. INSTALL AIRBAG SENSOR FRONT LH
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.

CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.

c. Install the airbag sensor front LH with the 2 bolts.

Torque: 9.0 Nm (92 kgf.cm, 80 in.lbf)

NOTE:
- If the airbag sensor front LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the airbag sensor front LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

d. Connect the connector to the airbag sensor front LH.
e. Check that there is no looseness in the installation parts of the airbag sensor front LH.

8. INSTALL LH HEADLAMP ASSEMBLY
9. HEADLIGHT AIM ONLY
10. CONNECT BATTERY NEGATIVE TERMINAL
11. INSPECT SRS WARNING LIGHT