Removal and Replacement
REMOVAL1. REMOVE DECK FLOOR BOX FRONT
2. REMOVE DECK FLOOR BOX REAR
3. REMOVE REAR FLOOR FINISH PLATE
a. Using a screwdriver, remove the 2 clips labeled A and 2 clips labeled B, 4 clips labeled C and finish plate.
HINT: Tape the screwdriver tip before use.
4. REMOVE QUARTER PANEL MUDGUARD SUB-ASSEMBLY REAR LH (w/ Mudguard)
a. Remove the 3 clips, screw and mudguard.
5. REMOVE QUARTER PANEL MUDGUARD SUB-ASSEMBLY REAR RH (w/ Mudguard)
HINT: Use the same procedure described for the LH side.
6. REMOVE REAR BUMPER COVER
a. Put protective tape under the quarter panel.
b. Remove the 6 screws, 4 nuts and 2 clips.
c. Using a screwdriver, disengage the claw labeled A, 4 claws labeled B and bumper cover.
HINT: Tape the screwdriver tip before use.
INSTALLATION
1. INSTALL FRONT BUMPER COVER
a. Install the bumper cover with the 6 screws.
Torque: 5.5 N.m (55 kgf.cm, 49 in.lbf)
2. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
4. INSTALL RADIATOR GRILLE