Drive Belt: Service and Repair

DRIVE BELT

COMPONENTS:

REMOVAL
1. REMOVE FRONT WHEEL RH
2. REMOVE ENGINE UNDER COVER NO. 1
3. REMOVE FRONT FENDER APRON SEAL RH

4. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO. 1
a. Loosen bolts A and B.
b. Loosen adjusting bolt C and remove the belt.

5. REMOVE VANE PUMP V BELT
a. Loosen bolts A and B, and remove the belt.

INSTALLATION

1. INSTALL VANE PUMP V BELT
a. Install the belt on each pulley
b. Using a bar, adjust the belt tension and tighten bolt B.
Torque: 43 Nm (438 kgf-cm, 32 ft. lbs.)
c. Tighten bolt A.
Torque: 43 Nm (438 kgf-cm, 32 ft. lbs.)

2. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO. 1
a. Install the belt on each pulley.
b. Tighten adjusting bolt C, and adjust the belt tension.
c. First tighten bolt A, and then B.
Torque:
Bolt A 58 Nm (591 kgf-cm, 43 ft. lbs.)
Bolt B 18 Nm (184 kgf-cm, 13 ft. lbs.)
3. INSPECT DRIVE BELT TENSION
4. INSTALL FRONT WHEEL RH