Drive Belt: Testing and Inspection

INSPECT V-RIBBED BELT
a. Using a belt tension gauge, check the belt tension.
Belt tension gauge:
DENSO BTG-20 (95506-00020)
Burroughs No. BT-33-73F

Drive Belt Tension:

HINT:
^ "New belt" is a belt which has been used for less than 5 minutes on a running engine.
^ "Used belt" is a belt which has been used on a running engine for 5 minutes or more.
^ After installing a new belt, run the engine for approximately 5 minutes and then recheck the tension.





b. After installing the drive belt, check that it fits properly in the ribbed grooves. Check that the belt has not slipped out of the groove on the bottom of the crank pulley with your hand.