Central Control Module: Service and Repair
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
3. REMOVE INSTRUMENT PANEL NO.2 FINISH PANEL LOWER
4. REMOVE NETWORK GATEWAY ECU
a. Disconnect the connector.
b. Remove the bolt and network gateway ECU.
INSTALLATION
1. INSTALL NETWORK GATEWAY ECU
a. Install the network gateway ECU with the bolt.
b. Connect the connector.
2. INSTALL INSTRUMENT PANEL NO.2 FINISH PANEL LOWER
3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION
NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal.