Removal and Installation

REMOVAL

1. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1




2. REMOVE GENERATOR ASSEMBLY
a. Remove the wire harness clamp [A].
b. Disconnect the generator connector[B].
c. Open the terminal cap, remove the nut and disconnect the generator wire [C].




d. Loosen bolts A and B.
e. Loosen bolt C to lessen the tension of the V belt.




f. Remove bolts A and B, and the generator.


INSTALLATION




1. INSTALL GENERATOR ASSEMBLY
a. Temporarily install the generator with bolts A and B.




b. Adjust the V belt tension by tightening bolt C.
c. Tighten bolts A and B.

Torque:
Bolt A: 58 N.m (592 kgf.cm, 43 ft.lbf)
Bolt B: 18 N.m (184 kgf.cm, 13 ft.lbf)

d. Install the generator wire with the nut.

Torque: 9.8 N.m (100 kgf.cm, 7.0 ft.lbf)

e. Connect the generator connector.
f. Install the wire harness clamp.

2. INSPECT V BELT