Power Point Socket (Rear)
REMOVAL1. REMOVE TONNEAU COVER ASSEMBLY
2. REMOVE DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat)
3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Rear No. 2 Seat)
4. REMOVE DECK BOARD SUB-ASSEMBLY NO.3
5. REMOVE DECK BOARD SUB-ASSEMBLY NO.2
6. REMOVE DECK FLOOR BOX REAR
7. REMOVE DECK FLOOR BOX FRONT (w/o Rear No. 2 Seat)
8. REMOVE REAR FLOOR FINISH PLATE
9. REMOVE DECK SIDE TRIM BOX LH
10. REMOVE REAR DOOR SCUFF PLATE LH (w/o Rear No. 2 Seat)
11. REMOVE REAR DOOR SCUFF PLATE LH (w/ Rear No. 2 Seat)
12. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
13. REMOVE BACK DOOR WEATHERSTRIP
14. REMOVE ROPE HOOK
15. REMOVE DECK SIDE TRIM COVER LH (w/o Rear No. 2 Seat)
16. REMOVE DECK SIDE TRIM COVER LH (w/ Rear No. 2 Seat)
17. REMOVE REAR COMBINATION LIGHT SERVICE COVER LH
18. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (w/o Rear No. 2 Seat)
19. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (w/ Rear No. 2 Seat)
20. REMOVE REAR POWER POINT SOCKET
a. Using a screwdriver, disengage the claw on the rear power point socket cover from the hole in the rear power point socket. Then pull out the rear power point socket approximately 10 mm (0.39in.).
HINT: Tape the screwdriver tip before use.
b. Using a screwdriver, disengage the claw on the rear power point socket cover from body and remove the rear power point socket and cover as a unit. c. Disconnect the connector.
d. Disassemble the rear power point socket from the rear power point socket cover.
INSTALLATION
1. INSTALL REAR POWER POINT SOCKET
a. Assemble the rear power point socket to the rear power point socket cover at the position 10 mm (0.39 in.) away from full lock position and ensure that they are temporarily locked.
b. Place the cut-out on the trim with the claw on the rear power point socket cover and install the rear power point socket and cover to the trim.
c. After installing them, fully push in the rear power point socket to install it.
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (w/ Rear No. 2 Seat)
3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (w/ o Rear No. 2 Seat)
4. INSTALL REAR COMBINATION LIGHT SERVICE COVER LH
5. INSTALL DECK SIDE TRIM COVER LH (w/ Rear No. 2 Seat)
6. INSTALL DECK SIDE TRIM COVER LH (w/o Rear No. 2 Seat)
7. INSTALL ROPE HOOK
8. INSTALL BACK DOOR WEATHERSTRIP
9. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
10. INSTALL REAR DOOR SCUFF PLATE LH (w/ Rear No. 2 Seat)
11. INSTALL REAR DOOR SCUFF PLATE LH (w/o Rear No. 2 Seat)
12. INSTALL DECK SIDE TRIM BOX LH
13. INSTALL REAR FLOOR FINISH PLATE
14. INSTALL DECK FLOOR BOX FRONT (w/o Rear No. 2 Seat)
15. INSTALL DECK FLOOR BOX REAR
16. INSTALL DECK BOARD SUB-ASSEMBLY NO.3
17. INSTALL DECK BOARD SUB-ASSEMBLY NO.2
18. INSTALL DECK BOARD SUB-ASSEMBLY (w/ Rear No. 2 Seat)
19. INSTALL DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat)
20. INSTALL TONNEAU COVER ASSEMBLY