Diagnostic Start Up/Finish

HINT:
- Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle.
- If the system cannot enter the diagnosis mode, inspect all AVC-LAN communication signals and repair or replace problem parts.
- After the ignition switch is turned on, check that the map is displayed before starting the diagnostic mode. Otherwise, some items cannot be checked.

START DIAGNOSTIC MODE
a. There are 2 methods to start diagnostic mode. Start the mode by using one of them.




b. Method 1
1. READY-on state.
2. While pressing and holding the "INFO" switch, operate the light control switch: OFF -> Turn ON -> Turn OFF -> Turn ON -> Turn OFF -> Turn ON -> Turn OFF.
3. The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result will be displayed.




c. Method 2
1. READY-on state.
2. Switch to the "Display Check" screen.
3. From the display quality adjustment screen, touch the corners of the screen in the following order: upper left -> lower left -> upper left -> lower left -> upper left -> lower left.
4. The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result will be displayed.

FINISH DIAGNOSTIC MODE
a. There are 2 methods to end diagnostic mode. Use one of them.
1. Turn the ignition switch off.
2. Press and hold the "DISP" switch for 3 seconds.

DIAGNOSIS MENU




a. The "Diagnosis MENU" screen will be displayed by pressing the menu switch on the "System Check Mode" screen.