Overhaul
DISASSEMBLY1. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO.2
a. Disengage the 4 clips, then remove the instrument cluster finish panel garnish No. 2.
2. REMOVE AUTOMATIC LIGHT CONTROL SENSOR
a. Disconnect the connector.
b. Remove the automatic light control sensor.
3. REMOVE COOLER (SOLAR SENSOR) THERMISTOR
a. Disconnect the connector.
b. Remove the cooler (solar sensor) thermistor.
NOTE: Do not pry the cooler (solar sensor) thermistor off from the upper position.
4. REMOVE INSTRUMENT PANEL PIN NO.1
5. REMOVE DEFROSTER NOZZLE ASSEMBLY
a. Remove the 7 screws and the defroster nozzle assembly.a. Remove the 3 screws and the 3 instrument panel pin No. 1.
6. REMOVE SIDE DEFROSTER NOZZLE DUCT NO.1
a. Remove the screw and the defroster nozzle duct No. 1.
7. REMOVE SIDE DEFROSTER NOZZLE DUCT NO.2
a. Remove the screw and the side defroster nozzle duct No. 2.
8. REMOVE HEATER TO REGISTER DUCT NO.1
a. Remove the clip.
b. Remove the 3 screws and the heater to register duct No. 1.
9. REMOVE HEATER TO REGISTER DUCT NO.4
a. Remove the clip.
b. Remove the 3 screws and the heater to register duct No. 4.
10. REMOVE HEATER TO REGISTER CENTER SUB DUCT
a. Remove the 4 screws and the heater to register center sub duct.
11. REMOVE INSTRUMENT PANEL REGISTER ASSEMBLY LOWER NO.1
a. Remove the 2 screws and the instrument panel register assembly lower No. 1.
12. REMOVE INSTRUMENT PANEL REGISTER ASSEMBLY NO.1
a. Remove the 2 screws and the instrument panel register assembly No. 1.
13. REMOVE INSTRUMENT PANEL BRACKET SUB-ASSEMBLY CENTER
a. Remove the 3 screws and the instrument panel bracket sub-assembly center.
14. REMOVE NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)
15. REMOVE INSTRUMENT PANEL WIRE
16. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
REASSEMBLY
1. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
2. INSTALL INSTRUMENT PANEL WIRE
3. INSTALL NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)
4. INSTALL INSTRUMENT PANEL BRACKET SUB-ASSEMBLY CENTER
5. INSTALL INSTRUMENT PANEL REGISTER ASSEMBLY NO.1
6. INSTALL INSTRUMENT PANEL REGISTER ASSEMBLY LOWER NO.1
7. INSTALL HEATER TO REGISTER CENTER SUB DUCT
8. INSTALL HEATER TO REGISTER DUCT NO.4
9. INSTALL HEATER TO REGISTER DUCT NO.1
10. INSTALL SIDE DEFROSTER NOZZLE DUCT NO.2
11. INSTALL SIDE DEFROSTER NOZZLE DUCT NO.1
12. INSTALL DEFROSTER NOZZLE ASSEMBLY
13. INSTALL INSTRUMENT PANEL PIN NO.1
14. INSTALL COOLER (SOLAR SENSOR) THERMISTOR
15. INSTALL AUTOMATIC LIGHT CONTROL SENSOR
16. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH NO.2