Without Scan Tool

DTC CLEAR (WHEN USING SST CHECK WIRE)

a. DTC clear




1. Using SST, connect terminals TC and CG of the DLC3.

SST 09843- 18040

2. Turn the ignition switch on.
3. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
4. Check that the ABS warning and brake control lights and multi information display indicate the normal system code.




5. Remove the SST from the terminals of the DLC3.

HINT: Clearing the DTCs cannot be performed by removing the battery cable or the ECU- IG NO.1 fuse.

END OF DTC CLEAR (WHEN USING SST CHECK WIRE)

a. Turn the ignition switch on.
b. Check that the ABS and brake control warning lights go off within approximately 3 seconds.