Removal

CYLINDER HEAD

COMPONENTS:

COMPONENTS:

COMPONENTS:

COMPONENTS:

COMPONENTS:

COMPONENTS:

COMPONENTS:

REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE
a. Discharge fuel system pressure.
2. REMOVE FRONT SUSPENSION BRACE SUB-ASSEMBLY UPPER CENTER
a. w/Front suspension brace upper center.
3. DRAIN COOLANT
4. DRAIN TRANSFER OIL (for 4WD)
5. DISCONNECT RADIATOR HOSE OUTLET
6. DISCONNECT UNION TO CONNECTOR TUBE HOSE
7. DISCONNECT HEATER INLET WATER HOSE
8. DISCONNECT FUEL TUBE SUB-ASSEMBLY
a. Disconnect the fuel tube sub-assembly.
9. SEPARATE FRONT DRIVE SHAFT ASSEMBLY RH (for 4WD)





10. SEPARATE ENGINE MOUNTING INSULATOR ASSEMBLY RR (for 4WD)
a. Remove the 2 bolts and disconnect the engine mounting insulator.
11. REMOVE ENGINE MOUNTING BRACKET RR (for 4WD)
12. REMOVE INTAKE MANIFOLD
13. DISCONNECT ENGINE WIRE
14. REMOVE INTAKE MANIFOLD INSULATOR NO. 1
15. REMOVE EXHAUST MANIFOLD HEAT INSULATOR NO. 1
16. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
17. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
18. REMOVE CHAIN SUB-ASSEMBLY
19. REMOVE NO. 2 CAMSHAFT
20. REMOVE CAMSHAFT
21. REMOVE CAMSHAFT BEARING NO. 2





22. REMOVE CYLINDER HEAD SUB-ASSEMBLY
a. Using a 10 mm Bi-hexagon wrench, uniformly loosen the 10 bolts in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.

NOTICE:
^ Be careful not to drop washers into the cylinder head.
^ Head warpage or cracking could result from removing bolts in an incorrect order.

23. REMOVE CYLINDER HEAD GASKET