Engine Control Module: Service and Repair

ECM:

REMOVAL

1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE RH
3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
4. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
5. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER NO.2

6. REMOVE ECM

a. Remove the 2 wire harness clamps.
b. Disconnect the 5 ECM connectors.
c. Remove the 2 nuts and ECM.

7. REMOVE ECM BRACKET NO.1

a. Remove the 2 screws and ECM bracket.

8. REMOVE ECM BRACKET NO.2

a. Remove the 2 screws and ECM bracket.

INSTALLATION

1. INSTALL ECM BRACKET NO.2

a. Install the ECM bracket with the 2 screws.

2. INSTALL ECM BRACKET NO.1

a. Install the ECM bracket with the 2 screws.

3. INSTALL ECM

a. Install the 2 wire harness clamps.
b. Connect the 5 ECM connectors.
c. Install the ECM with the 2 nuts.

Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)

4. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER NO.2
5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
7. INSTALL FRONT DOOR SCUFF PLATE RH
8. CONNECT BATTERY NEGATIVE TERMINAL