Front Door: Adjustments
ADJUSTMENT1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. INSPECT FRONT DOOR
a. Check that the clearance is within the standard range.
3. ADJUST FRONT DOOR
a. Using a SST, loosen the bolts on the body side to adjust the door front and back, up and down.
SST 09812-00010
Torque: 23 N.m (235 kgf.cm, 17 ft.lbf)
b. Loosen the bolts on the door side to adjust the door up and down, and the door front side to side.
Torque: 27 N.m (275 kgf.cm, 20 ft.lbf)
HINT: Perform this procedure after replacing the centering bolt with the supplied bolt.
c. When adjusting the door rear side to side and the front door lock striker plate assembly, use a "torx" socket wrench (T40) to loosen the screws until the striker can move. Lightly tap it with a brass bar for adjustment.
Torque: 23 N.m (235 kgf.cm, 17 ft.lbf)
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION