Removal and Installation
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER NO.2
4. REMOVE HYBRID VEHICLE CONTROL ECU
a. Disconnect the 6 connectors from the hybrid vehicle control ECU.
b. Remove the 2 nuts and hybrid vehicle control ECU.
5. REMOVE ECM BRACKET NO.1
a. Remove the 2 screws and ECM bracket No.1.
6. REMOVE ECM BRACKET NO.2
a. Remove the 2 screws and ECM bracket No.2.
INSTALLATION
1. INSTALL ECM BRACKET NO.2
a. Install the ECM bracket No.2 with the 2 screws.
2. INSTALL ECM BRACKET NO.1
a. Install the ECM bracket No.1 with the 2 screws.
3. INSTALL HYBRID VEHICLE CONTROL ECU
a. Install the hybrid vehicle control ECU with the 2 nuts.
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
b. Connect the 6 connectors to the hybrid vehicle control ECU.
4. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER NO.2
5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Some systems need initialization when disconnecting the cable from the negative battery terminal.