Operation Check

OPERATION CHECK

1. ILLUMINATED ENTRY SYSTEM OPERATION CHECK
a. Illuminated entry system controls the following lights:
- Ignition key cylinder light
- Interior light (Room light assembly)
- Personal light (Overhead J/B)

b. Check that the lights come on after:
1. Unlocking any door that was closed and locked with the ignition switch off.

c. Check that the lights fade out after:
1. Leaving the doors unlocked for 15 seconds
2. Turning the ignition switch to the ACC or ON position
3. Locking all the doors

d. Check that the lights stay ON for at least 15 seconds after opening any of the doors, then fade out again after 15 seconds.

e. Check that the lights fade out after:
1. Leaving the doors unlocked for 15 seconds
2. Locking all the doors

f. Check that the lights stay ON for at least 15 seconds after opening any of the doors, then fade out again in 15 seconds after closing all the doors.
g. Check that the lights come on when opening any of the doors or turning the ignition switch off from the ACC or ON position.

2. LIGHT AUTO TURN OFF OPERATION CHECK
a. Turn the ignition switch to the ON position, and switch the headlights into the TAIL or HEAD position.
b. Turn the ignition switch off and open the driver's door, and check that the headlights go off immediately.
c. Turn the ignition switch to the ON position, and switch the headlights into the AUTO position.
d. Turn the ignition switch off and open the driver's door when operating the automatic light control system, and check that the headlights go off immediately.

3. AUTOMATIC LIGHT CONTROL OPERATION CHECK

HINT: Perform the operation check at a location with bright surroundings.

a. Turn the ignition switch to the ON position.
b. Turn the headlight dimmer switch to the AUTO position.
c. Cover the automatic light control sensor and check that the taillight and headlight in order.
d. Uncover the automatic light control sensor and check that the headlight and taillight go off in order.

4. DAYTIME RUNNING LIGHT OPERATION CHECK
a. Check that the high beams come on when the headlight switch is off with the engine running and the parking brake released. Then check that the lights go off under the following conditions:
1. Turn the headlight dimmer switch into the TAIL or HEAD (LOW) position.
2. Turn the ignition switch off.