Side Airbag Sensor
Side Airbag Sensor:
SIDE AIRBAG SENSOR
REMOVAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION: Read PRECAUTION, refer to Restraint Systems Service Precautions thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE FRONT DOOR SCUFF PLATE LH (w/ Rear No. 2 Seat)
4. REMOVE FRONT DOOR SCUFF PLATE LH (w/o Rear No. 2 Seat)
5. REMOVE REAR DOOR SCUFF PLATE LH (w/ Rear No. 2 Seat)
6. REMOVE REAR DOOR SCUFF PLATE LH (w/o Rear No. 2 Seat)
7. REMOVE REAR DOOR WEATHERSTRIP LH
8. REMOVE FRONT DOOR WEATHERSTRIP LH
9. REMOVE CENTER PILLAR GARNISH LOWER LH (w/ Rear No. 2 Seat)
10. REMOVE CENTER PILLAR GARNISH LOWER LH (w/ o Rear No. 2 Seat)
11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY
12. REMOVE SIDE AIRBAG SENSOR LH
a. Disconnect the connector from the side airbag sensor LH.
b. Remove the 3 bolts and the side airbag sensor LH.
INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. INSTALL SIDE AIRBAG SENSOR LH
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
c. Install the side airbag sensor LH with the 3 bolts.
Torque: 17.5 N.m (179 kgf.cm, 13 ft.lbf)
NOTE:
- If the side airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the side airbag sensor LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
d. Check that there is no looseness in the installation parts of the side airbag sensor LH.
e. Connect the connector to the side airbag sensor LH.
2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY
3. INSTALL CENTER PILLAR GARNISH LOWER LH (w/ Rear No. 2 Seat)
4. INSTALL CENTER PILLAR GARNISH LOWER LH (w/ o Rear No. 2 Seat)
5. INSTALL FRONT DOOR WEATHERSTRIP LH
6. INSTALL REAR DOOR WEATHERSTRIP LH
7. INSTALL FRONT DOOR SCUFF PLATE LH (w/ Rear No. 2 Seat)
8. INSTALL FRONT DOOR SCUFF PLATE LH (w/o Rear No. 2 Seat)
9. INSTALL REAR DOOR SCUFF PLATE LH (w/ Rear No. 2 Seat)
10. INSTALL REAR DOOR SCUFF PLATE LH (w/o Rear No. 2 Seat)
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12. PERFORM INITIALIZATION
a. Perform initialization.
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
13. INSPECT SRS WARNING LIGHT
a. Inspect the SRS warning light.