Rear Speed Sensor
INSTALLATIONHINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed are for the LH side.
1. INSTALL REAR SPEED SENSOR LH
a. Install the speed sensor with the bolt.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
NOTE: Keep the sensor tip and sensor installation hole free from foreign matter.
b. Install the sensor wire harness to the frame, upper control arm and axle housing with the 6 resin clips.
NOTE: Do not twist the sensor wire when installing it.
c. Install the clamp bolt to the upper control bracket.
Torque: 13 N.m (130 kgf.cm, 9 ft..lbf)
NOTE: Do not twist the sensor wire when installing it.
d. Connect the speed sensor connector.
NOTE: Do not twist the sensor wire when installing it.
2. INSTALL REAR WHEEL
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
5. CHECK ABS SPEED SENSOR SIGNAL
a. Check the ABS speed sensor signal.