Damping Force Control Actuator
ON-VEHICLE INSPECTION1. INSPECT GAS CHAMBER
HINT: Before conducting this inspection, check that front and rear shock absorber neutral pressure are within the specified range.
a) Start the engine with the vehicle unloaded (with fuel tank full) and adjust the vehicle height to the "LO" position.
b) Record the graduation on the reservoir tank. (A)
c) Adjust the vehicle height from LO position to "HI" position.
d) Note the graduations on the reservoir tank (B). Inspect that the value (A - B) is within the standard value.
Standard value: A - B = 7 graduations or more
NOTICE: Perform the inspection 30 seconds after "H" indicator light has changed flushing to light up. If the value is not within the specification, replace all the gas chambers with new ones.
INSPECTION
1. INSPECT DAMPING FORCE CONTROL ACTUATOR
a) Disconnect the damping force control actuator connector.
b) Measure resistance between each terminal of damping force control actuator.
Standard Resistance:
