Rear View Monitor System
TERMINALS OF ECU1. TELEVISION CAMERA ASSEMBLY
a. Disconnect the T10 camera connector.
b. Measure the voltage and resistance of each terminal of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side.
c. Reconnect the T10 camera connector.
d. Measure the voltage and frequency of each terminal of the connector.
If the result is not as specified, the camera may have a malfunction.
e. Reference:
Oscilloscope waveform
1. Waveform 1
2. RADIO AND NAVIGATION ASSEMBLY
Terminals Of Control Module/Pinouts (Part 1):
Terminals Of Control Module/Pinouts (Part 2):
Terminals Of Control Module/Pinouts (Part 3):
Oscilloscope Waveform:
a. Reference: waveform 1
HINT:
- Terminal: VV+ - VV-
- Gauge set: 200 mV/DIV, 10 micro second/DIV
- Condition: DVD is played on radio and navigation assembly
Oscilloscope Waveform:
b. Reference: waveform 2
HINT:
- Terminal: V+ - CGND
- Gauge set: 0.2 V/DIV, 0.2 micro second/DIV
- Condition: Ignition switch: ON, shift lever: R position