Back Door

BACK DOOR

Back Door:

Back Door:

DISASSEMBLY

1. REMOVE BACK DOOR GARNISH CENTER





a. Using a clip remover, disengage the 5 clips and remove the garnish center.

2. REMOVE BACK DOOR SIDE GARNISH LH
a. Using a clip remover, disengage the 3 clips and remove the side garnish.

3. REMOVE BACK DOOR SIDE GARNISH RH
a. Using a clip remover, disengage the 3 clips and remove the side garnish.

4. REMOVE BACK DOOR PULL STRAP





a. Using a screwdriver, disengage the claws and remove the strap cover.

HINT: Tape the screwdriver tip before use.

b. Remove the bolt and strap.

5. REMOVE BACK DOOR TRIM BOARD ASSEMBLY





a. Using the screwdriver, disengage the 14 clips and remove the trim board.

HINT: Tape the screwdriver tip before use.

b. Remove the service hole cover from the trim board.

6. REMOVE BACK-UP LIGHT ASSEMBLY LH
7. REMOVE BACK-UP LIGHT ASSEMBLY RH
8. REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE
9. REMOVE BACK DOOR LOCK ASSEMBLY





a. Disconnect the connector.
b. Remove the 3 bolts and lock.

10. REMOVE BACK DOOR BASE STOPPER BRACKET
a. Remove the 4 bolts and 2 stopper brackets.

11. REMOVE BACK DOOR STOPPER LOWER
a. Remove the 4 bolts and 2 stoppers.

12. REMOVE REAR SPOILER COVER
13. REMOVE BACK DOOR STAY SUB-ASSEMBLY LH
14. REMOVE BACK DOOR STAY SUB-ASSEMBLY RH

REASSEMBLY

1. INSTALL BACK DOOR STOPPER LOWER
a. Install the 2 stoppers with the 4 bolts.

Torque: 7.0 N.m (71 kgf.cm, 62 in.lbf)

2. INSTALL BACK DOOR BASE STOPPER BRACKET
a. Install the 2 stopper brackets with the 4 bolts.

Torque: 7.0 N.m (71 kgf.cm, 62 in.lbf)

3. INSTALL BACK DOOR LOCK ASSEMBLY





a. Install the lock with the 3 bolts.

Torque: 12.5 N.m (112 kgf.cm, 9 ft.lbf)

4. INSTALL BACK DOOR PULL STRAP





a. Install the strap with the bolt.

Torque: 5.0 N.m (51 kgf.cm, 42 in.lbf)

b. Install the strap cover.