Operation CHARM: Car repair manuals for everyone.

Pinout Values and Diagnostic Parameters

TERMINALS OF ECU

1. CHECK DRIVER SIDE J/B ASSEMBLY (MULTIPLEX NETWORK BODY ECU)

Terminals Of Control Module/Pinouts - Check Driver Side J/B Assembly (Multiplex Network Body ECU) (Part 1):




a. Disconnect the 1C, 1J, 1L, 1K, 1P, B6, B7 and B9 J/ B connectors.

Terminals Of Control Module/Pinouts - Check Driver Side J/B Assembly (Multiplex Network Body ECU) (Part 2):




b. Measure the voltage and resistance according to the value(s) in the table.

Terminals Of Control Module/Pinouts - Check Driver Side J/B Assembly (Multiplex Network Body ECU) (Part 3):




Terminals Of Control Module/Pinouts - Check Driver Side J/B Assembly (Multiplex Network Body ECU) (Part 4):




c. Reconnect the J/B and ECU connectors and measure the voltage according to the value(s) in the table.

2. CHECK POWER BACK DOOR ECU (w/ Power back door system)

Terminals Of Control Module/Pinouts - Check Power Back Door ECU (w/power Back Door System) (Part 1):




a. Disconnect the P13 and P14 ECU connectors.

Terminals Of Control Module/Pinouts - Check Power Back Door ECU (w/power Back Door System) (Part 2):




b. Measure the voltage and resistance according to the value(s) in the table.

HINT: If the result is not as specified, there may be a malfunction on the wire harness side.

Terminals Of Control Module/Pinouts - Check Power Back Door ECU (w/power Back Door System) (Part 3):




c. Reconnect the ECU connectors and measure the voltage according to the value(s) in the table.

HINT: If the result is not as specified, the ECU may have a malfunction.