Component Tests and General Diagnostics
INSPECTION1. INSPECT TIRES
(a) Check the tires for wear and proper inflation pressure.
Cold Tire Inflation Pressure:
(b) Using a dial indicator, check the runout of the tires.
Tire runout: 1.4 mm (0.055 inch) or less
2. ROTATE TIRES
HINT: Rotate the tires as shown in the illustration.
3. INSPECT WHEEL BALANCE (for Steel Wheel)
(a) Check and adjust the off-the-car balance.
Imbalance after adjustment: 8.0 g (0.018 lb.) or less.
HINT: If necessary, check and adjust the on-the-car balance.
4. INSPECT WHEEL BALANCE (for Non-steel Wheel)
(a) Check and adjust the off-the-car balance.
Imbalance after adjustment: 8.0 g (0.018 lb.) or less.
NOTICE:
^ Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
^ Do not touch the sticking surface of the tape.
^ Adhere the sticking type balance weight to the flat position shown in the illustration.
^ Push the balance weight securely with a finger to adhere it to the position.
^ Do not reuse the balance weight.
HINT:
^ The inner side balance weight should be installed by clipping it to the rim.
^ If necessary, check and adjust the on-the-car balance.
5. INSPECT FRONT AXLE HUB BEARING LOOSENESS
6. INSPECT REAR AXLE HUB BEARING LOOSENESS
7. INSPECT FRONT AXLE HUB RUNOUT
8. INSPECT REAR AXLE HUB RUNOUT