Variable Valve Timing Actuator Position Sensor: Service and Repair
REMOVAL1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
2. REMOVE FRONT OUTER COWL TOP PANEL SUBASSEMBLY
3. DRAIN ENGINE COOLANT
4. REMOVE V-BANK COVER SUB-ASSEMBLY
5. REMOVE NO. 2 AIR CLEANER INLET
6. REMOVE NO. 1 AIR CLEANER INLET
7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
9. REMOVE INTAKE AIR SURGE TANK ASSEMBLY
10. REMOVE VVT SENSOR (for Bank 1 Intake Side)
a. Disconnect the VVT sensor connector.
b. Remove the bolt and VVT sensor.
11. REMOVE VVT SENSOR (for Bank 1 Exhaust Side)
a. Disconnect the VVT sensor connector.
b. Remove the bolt and VVT sensor.
12. REMOVE VVT SENSOR (for Bank 2 Intake Side)
a. Disconnect the VVT sensor connector.
b. Remove the bolt and VVT sensor.
13. REMOVE VVT SENSOR (for Bank 2 Exhaust Side)
a. Disconnect the VVT sensor connector.
b. Remove the bolt and VVT sensor.
INSTALLATION
1. INSTALL VVT SENSOR (for Bank 2 Exhaust Side)
a. Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf.cm, 7 ft. lbs.)
b. Connect the VVT sensor connector.
2. INSTALL VVT SENSOR (for Bank 2 Intake Side)
a. Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf.cm, 7 ft. lbs.)
b. Connect the VVT sensor connector.
3. INSTALL VVT SENSOR (for Bank 1 Exhaust Side)
a. Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf.cm, 7 ft. lbs.)
b. Connect the VVT sensor connector.
4. INSTALL VVT SENSOR (for Bank 1 Intake Side)
a. Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf.cm, 7 ft. lbs.)
b. Connect the VVT sensor connector.
5. INSTALL INTAKE AIR SURGE TANK ASSEMBLY
6. INSTALL AIR CLEANER CASE SUB-ASSEMBLY
7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
8. INSTALL NO. 1 AIR CLEANER INLET
9. INSTALL NO. 2 AIR CLEANER INLET
10. ADD ENGINE COOLANT
11. INSPECT FOR ENGINE COOLANT LEAK
12. INSPECT FOR ENGINE OIL LEAK
13. INSTALL V-BANK COVER SUB-ASSEMBLY
14. INSTALL FRONT OUTER COWL TOP PANEL SUBASSEMBLY
15. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY