Camshaft Bearing

Camshaft Bearing Cap (for Bank 1)





Make sure of the marks and numbers on the camshaft bearing caps and place them in each proper position and direction.





Temporarily tighten the 8 bolts in the order shown in the illustration.
Torque 10 Nm (102 kgf-cm, 7 ft. lbs.)





Install the camshaft housing sub-assembly RH and tighten the 12 bolts in the order shown in the illustration.
Torque 28 Nm (286 kgf-cm, 21 ft. lbs.)





Tighten the 8 bolts in the order shown in the illustration.
Torque 16 Nm (163 kgf-cm, 12 ft. lbs.)

Camshaft Bearing Cap (for Bank 2)





Make sure of the marks and numbers on the camshaft bearing caps and place them in each proper position and direction.





Temporarily tighten the 8 bolts in the order shown in the illustration.
Torque 10 Nm (102 kgf-cm, 7 ft. lbs.)





Install the camshaft housing sub-assembly LH and tighten the 13 bolts in the order shown in the illustration.
Torque 28 Nm (286 kgf-cm, 21 ft. lbs.)





Tighten the 8 bolts in the order shown in the illustration.
Torque 16 Nm (163 kgf-cm, 12 ft. lbs.)