Crankshaft Main Bearing
CrankshaftMaximum taper and out-of-round 0.02 mm (0.0008 inch)
Maximum circle runout 0.06 mm (0.0024 inch)
Crankshaft pin diameter 52.992 to 53.000 mm (2.0863 to 2.0866 inch)
Standard thrust clearance 0.04 to 0.24 mm (0.0016 to 0.0094 inch)
Maximum thrust clearance 0.30 mm (0.0118 inch)
Thrust washer thickness 2.43 to 2.48 mm (0.0957 to 0.0976 inch)
Crankshaft bearing cap set bolt diameter
Standard 10.8 to 11.0 mm (0.4252 to 0.4331 inch)
Maximum 10.7 mm (0.4213 inch)
Crankshaft oil clearance
Standard 0.026 to 0.047 mm (0.0010 to 0.0019 inch)
Maximum 0.050 mm (0.0020 inch)
Main Bearing Cap
Step 1
Install and uniformly tighten the 16 crankshaft bearing cap bolts in the sequence shown in the illustration.
Torque 61 Nm (622 kgf-cm, 45 ft. lbs.)
Step 2
Mark the front of the bearing cap bolts with paint.
Retighten the bearing cap bolts 90° in the order above.
Check that the painted mark is now at a 90° angle to the front.
Bolt Length:
Install 8 new seal washers and uniformly tighten the 8 crankshaft bearing cap bolts in several steps and in the sequence shown in the illustration.
Torque 52 Nm (525 kgf-cm, 38 ft. lbs.)