Tire Monitor System - Initialization Procedure

PRE-DELIVERY SERVICE
PD119-06
REVISED

Title:
TIRE PRESSURE WARNING SYSTEM
INITIALIZATION PROCEDURE

Models:
'07 Sienna

December 7, 2006

TSB REVISION NOTICE:

^ January 19, 2007: Step 3 of the Initialization Procedure has been updated.

Previous versions of this TSB should be discarded.

Introduction

The 2007 model year Sienna is equipped with a direct-type Tire Pressure Warning System (TPWS). A Tire Pressure Warning System valve/sensor is mounted into each tire (except the spare tire), and the measured tire pressure data is transmitted through a Tire Pressure Warning System antenna/receiver to the TPWS ECU.

During Pre-Delivery Service (PDS), the tire pressure must be set to the specification as indicated on the Vehicle Loading and Tire Information label, located inside the driver's door jam. Follow the procedure below to initialize the TPWS.

NOTE:
The Tire Pressure Warning System valves/sensors are activated at the manufacturing plant. Only the initialization process is required during PDS.

Applicable Vehicles

^ 2007 model year Sienna vehicles.





Required SSTs





Warranty Information

Initialization Procedure





1. Adjust all tires (except the spare tire) to the standard tire inflation pressure, as indicated on the Tire and Loading Information label on the vehicle.

NOTE:

^ If there is great difference between the current temperature of the tire and wheel (for example: shop temperature) and expected temperature (for example: outdoor temperature), this needs to be considered when adjusting the tire pressure.

^ Adjust the tire pressure when the tires are cold.





2. Turn the ignition switch to the "ON" position and check that the the Low Tire Pressure Warning Light is OFF.





3. Push and hold the Tire Pressure Warning "SET" Switch for 3 seconds until the Low Tire Pressure Warning Light blinks 3 times and then turns OFF, indicating the system initialization has begun.

The ignition switch MUST be left in the "ON" position for AT LEAST 7 minutes for initialization to complete.

4. Connect the Diagnostic Tester to DLC3.

5. Select the Tire Pressure Warning System Data List.

6. Confirm that each tire pressure on the Diagnostic Tester Data List shows the set value from step 1.

^ If the tire pressure is correct, initialization is complete.

^ If the tire pressure is incorrect, check the tire pressure gauge and repeat steps 1 - 6.