Canada - Electrical - Warning Lamp ON/No Shift From PARK

Bulletin
3115

Issue Date
February 5, 2009

Market
Canada

Title:
IG1 RELAY FREEZING

Component
BODY ELECTRICAL

Models
'06-'09, Highlander, Prius, RAV4, Sienna, '09 Corolla & Matrix

TSB REVISION NOTICE:
- February 10, 2009: The Applicable Vehicle Information table has been updated.
Previous versions of this TSB should be discarded.

INTRODUCTION:
Some customers may experience multiple warning lights illuminated, vehicle not shifting from Park to Drive, and other accessories becoming inoperative after the vehicle has cold soaked in sub freezing(below -10°C [14°F]) ambient air temperatures. A newly designed relay has been made available to improve this condition. Use the following procedure to address this concern.







APPLICABILITY:







PARTS INFORMATION:







WARRANTY INFORMATION:







REQUIRED TOOLS & EQUIPMENT:

Additional ETAS Techstream units may be ordered by completing the order form on ETAS and faxing it to (416) 431-8342

REPAIR PROCEDURE:







1. Locate the instrument panel junction block No. 1 in the Instrument Panel (as shown in Figure 1).
2. Remove the relay and verify the part number located on the side of the relay.
A. If the part number is 90987-02025 or 90987-02030, replace the relay with the countermeasure relay P/N 90987- 02031.
B. If the part number is 90987-02031, then diagnose the specific conditions reported by the customer following the Repair Manual

3. Connect ETAS Techstream and clear any stored DTCs.

NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.