Without Scan Tool
DTC CLEARa. Clearing an individual DTC memory (when clearing the memory of the DTC detected in the past individually)
1. Press the preset switch 5ch for 2 seconds or more while ECHN is displayed in service check mode or detailed information mode.
HINT:
- A beep sound is emitted once when the DTC memory is completely cleared.
- When the DTC memory is cleared, only the component code (physical address) is displayed for the target component.
- To check DTCs, press the preset switch 1ch and perform the service check again.
b. Clearing all the DTC memories (when clearing all the memories of DTCs detected in the past)
1. Start diagnostic mode after repairing the trouble area.
2. Press the preset switch 5ch for 2 seconds or more (CLR is displayed at this time).
HINT:
- A beep sound is emitted once when the DTC memories are completely cleared.
- When the DTC memories for all the components are cleared, only the component codes (physical address) are displayed.
3. Press the preset switch 1ch to perform the service check again, and check that no DTCs are displayed for any component codes (physical address)
c. Finish diagnostic mode
1. Press DISC for 2 seconds or more, or turn the ignition switch off