Without Scan Tool

DIAGNOSTIC CHECK




a. Start diagnostic mode (All elements come on during SW check mode).

1. Turn off the audio system and turn the ignition switch to the ACC position. While pressing the preset switches 1ch and 6ch at the same time, press the DISC switch 3 times.

2. Reference:
- When the system enters diagnostic mode, a beep sound is emitted 3 times and all the elements come on during SW check mode.
- It takes approximately 40 seconds to complete the check.
- Turn on all the elements in the LCD.
- When pressing the switch, confirm that a beep sound is emitted.

b. Service check screen.

1. Press the SEEK TRACK UP switch to enter the service check screen.




2. In service check mode, the system check and the diagnostic memory check are performed, and the check results are displayed by component codes in ascending order (physical address).




c. Finish diagnostic mode.

1. Press the DISC switch for 2 seconds or more, or turn the ignition switch off.

d. Service check mode result display (for checking the current and the past system conditions).




1. Press the SEEK TRACK UP/DOWN switch to see the check result of each component.

The illustration shows the case that the system has 2 components with the codes 190 and 360, and that one of them (code 360) requires a check.

The check result is displayed by a component code in ascending order. The component device code is displayed first, and then the check result follows.




2. Check the result display.
3. To perform the service check again, press the preset switch 1 ch.

e. Detailed information mode (when displaying the DTC for a troubled component)

1. With CHEC or ECHN being displayed, press the preset switch 2ch to go to detailed information mode.







2. Press the SEEK TRACK UP/DOWN switch to display the system check result (SYS) and diagnostic memory response (CODE).

The illustration shows the case that the component with the code 190 has DTC 47 and DC as a result of the system check and the diagnostic memory response.

The detailed information mode shows the system check result first, then the diagnostic memory response result follows. (*2): As for the DTCs that do not have any sub codes, no sub code is displayed.




3. Displayed items in detailed information mode
4. Check the trouble area referring to the DTC list.
5. To return to the service check mode, press the preset switch 3ch.