Without Scan Tool

DTC CHECK (for Using a SST Check Wire)

a. Check DTCs.




1. Using SST, connect terminals TC and CG of the DLC3.
SST 09843-18040

2. Turn the ignition switch to the ON position.




3. Read 2-digit DTCs by observing the blinking of the ABS warning light on the combination meter.

HINT:
- If no code appears, inspect the ABS warning light circuit or TC and CG terminal circuit. Component Tests and General Diagnostics
- As an example, the blinking patterns of the normal system indication and DTCs 11 and 21 are as shown.
- DTCs are explained in DTC chart.

4. After completing the check, disconnect SST from terminals TC and CG of the DLC3, and turn the ignition switch to OFF.

HINT: If 2 or more malfunctions are detected at the same time, the lowest numbered DTC is displayed first.

END OF DTC CHECK

a. Turn the ignition switch to the ON position.
b. Check that the ABS warning light goes off within approximately 3 seconds.
c. Turn the ignition switch to OFF.