Inspection
ENGINE ASSEMBLYCOMPONENTS (Part 1):
COMPONENTS (Part 2):
COMPONENTS (Part 3):
COMPONENTS (Part 4):
COMPONENTS (Part 5):
COMPONENTS (Part 6):
COMPONENTS (Part 7):
COMPONENTS (Part 8):
COMPONENTS (Part 9):
COMPONENTS (Part 10):
COMPONENTS (Part 11):
COMPONENTS (Part 12):
COMPONENTS (Part 13):
COMPONENTS (Part 14):
COMPONENTS (Part 15):
COMPONENTS (Part 16):
INSPECTION
1. INSPECT INTAKE MANIFOLD FOR WARPAGE
(a) Using a precision straight edge and feeler gauge, measure the warpage of the contact surfaces of the cylinder head and intake air surge tank.
Maximum warpage:
0.8 mm (0.031 inch) for Intake air surge tank side
0.2 mm (0.008 inch) for Cylinder head side
If warpage is greater than the maximum, replace the intake manifold.
2. INSPECT EXHAUST MANIFOLD FOR WARPAGE
(a) Using a precision straight edge and feeler gauge, measure the warpage of the top surface of the cylinder head.
Maximum warpage: 0.7 mm (0.028 inch)
If warpage is greater than maximum, replace the exhaust manifold.
HINT: Maximum warpage of each installation surface: 0.3 mm (0.012 inch)