Scan Tool Testing and Procedures

DATA LIST / ACTIVE TEST
1. DATA LIST
(a) Turn the ignition switch OFF.
(b) Connect the intelligent tester to the DLC3.
(c) Turn the ignition switch to the ON position and turn the tester ON.
(d) Read DATA LIST by following the prompts on the tester screen.

Part 1:

Part 2:

Part 3:

HINT:
*1: Displayed only when the ID No. is not registered.
*2: It may take about 2 or 3 minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25.