Without Scan Tool

DTC CLEAR (USING SST CHECK WIRE)

a. Clear the DTCs.

1. When the ignition switch is turned off (turned to the lock position), the DTCs are cleared.

HINT: Depending on the DTCs, the DTCs may not be cleared by turning off the ignition switch. In this case, proceed to the next procedure.

2. Using SST, connect terminals TC and CG of the DLC3, and then turn the ignition switch to the ON position.
SST 09843-18040

3. Disconnect terminal TC of the DLC3 within 3 to 10 seconds after the DTCs being output, and check if the SRS warning light comes on within 3 seconds.
4. Within 2 to 4 seconds of the SRS warning light coming on, connect terminals TC and CG of the DLC3.
5. The SRS warning light should turn off within 2 to 4 seconds after connecting terminals TC and CG of the DLC3. Then, disconnect terminal TC within 2 to 4 seconds after the SRS warning light turning off.
6. The SRS warning light comes on again within 2 to 4 seconds after disconnecting terminal TC. Then, reconnect terminals TC and CG within 2 to 4 seconds after the SRS warning light coming on, connect terminals TC and CG of the DLC3.




7. Check if the SRS warning light turns off 2 to 4 seconds after connecting terminals TC and CG of the DLC3. Also check if the normal system indication is displayed within 1 second of the SRS warning light turning off.

If DTCs are not cleared, repeat this procedure until the codes are cleared.