SRS Warning Light Does Not Come ON

SRS Warning Light does not Come ON

DESCRIPTION

The SRS warning light is located on the combination meter assembly.

When the SRS (supplemental restraint system) is normal, the SRS warning light comes on for approximately 6 seconds after the ignition switch is turned from the LOCK position to the ON position, and then turns off automatically.

If there is a malfunction in the SRS, the SRS warning light comes on to inform the driver.

When terminals TC and CG of the DLC3 are connected, the SRS warning light blinks to indicate the DTCs stored in the center airbag sensor assembly.

Wiring Diagram:

INSPECTION PROCEDURE

CAUTION: In order to prevent unexpected airbag deployment, disconnect the following connectors before inspecting parts such as wire harnesses, if the application of tester probes to the center airbag sensor assembly connector is necessary.

a. Turn the ignition switch to the LOCK position.
b. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
c. Disconnect the connectors from the center airbag sensor assembly.
d. Disconnect the connectors from the steering pad.
e. Disconnect the connector from the front passenger airbag assembly.
f. Disconnect the connector from the front seat airbag assembly LH.
g. Disconnect the connector from the front seat airbag assembly RH.

HINT: Skip the following steps if side and curtain shield airbags are not fitted.

h. Disconnect the connector from the curtain shield airbag assembly LH.
i. Disconnect the connector from the curtain shield airbag assembly RH.
j. Disconnect the connector from the front seat outer belt assembly LH.
k. Disconnect the connector from the front seat outer belt assembly RH.

Step 1-2:

Step 2(Continued)-4:

Step 5-6: