Wheel Speed Sensor: Service and Repair
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE REAR SPEED SENSOR
a. Disconnect the speed sensor connector.
b. Remove the nut and speed sensor rear.
NOTE:
- Do not attach any foreign matter to the sensor tip.
- Ensure that no foreign matter enters the sensor installation hole.
INSTALLATION
1. INSTALL REAR SPEED SENSOR
a. Install the rear speed sensor with the nut.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
NOTE: Make sure that the sensor tip is clean.
b. Connect the speed sensor connector.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)
3. CHECK VSC SENSOR SIGNAL (w/VSC)
4. CHECK ABS SENSOR SIGNAL (w/o VSC)