Pressure Plate

Pressure Plate





CLUTCH COVER ASSEMBLY
Align the matchmarks on the clutch cover assembly and flywheel sub-assembly.
Following the procedures shown in the illustration, tighten the 6 bolts, in the order starting with the bolt located near the knock pin on the top.
Torque 19 Nm (195 kgf-cm, 14 ft. lbs.)

HINT: Following the order in the illustration, uniformly tighten the bolts.

Move SST up and down, right and left lightly, after checking that the disc is in the center, and tighten the bolts.