Canada - Instruments - Overhead Compass And Tempature Display

Bulletin
TSB3071R

Issue Date
January 27, 2009

Market
Canada

Title
OVERHEAD DIGITAL COMPASS & TEMPERATURE DISPLAY INOPERATIVE

Component
ELECTRICAL

Models
'05 -'09 Tacoma

TSB REVISION NOTICE:
- August 27, 2009: The OPN in the Warranty Information table has been updated.
Previous versions of this TSB should be discarded.

INTRODUCTION:

Some 2005 - 2009 model year Tacomas may experience a condition where there is no read out from the digital compass or temperature display in the overhead console. If this condition occurs, there is a new service part available. The new service part has the digital display separate from the overhead roof console box assembly. Please refer to the following instructions for the proper installation procedure of the new service part.






APPLICABLE VEHICLES:






WARRANTY INFORMATION:






PARTS INFORMATION:






REQUIRED SSTS:

NOTE:
Additional SSTs may be ordered by calling SPX/OTC at 1-800-933-8335.

REPAIR PROCEDURE:







1. Remove the roof console box assembly.
A. Remove the screw under the sunglass holder.
B. Disengage the 2 clips and 3 claws.
C. Disconnect the accessory meter connector and map lamp connector.







2. Remove the digital display
A. Remove the 3 T10 Torx fasteners holding the digital display into the roof console box assembly.

3. Reinstall the new digital display.
A. Reinstall the 3 T10 Torx fasteners holding the digital display into the roof console box assembly.

4. Reinstall the roof console box assembly (See Figure 1).
A. Connect the accessory meter connector and map lamp connector.
B. Reconnect the 3 claws and 2 clips.
C. Reinstall the single screw behind the sunglass holder.

5. Confirm proper operation of the digital display.
6. Calibrate the compass. Refer to the following Technical Service Bulletins for the initial calibration procedure.
- 2005/2006model year Tacoma: TSB 2111 "Initial Calibration of Compass During PDS"
- 2007 model year Tacoma: TSB 2634 "Initial Calibration of Compass During PDS"
- 2008 model year Tacoma: TSB 2880 "Initial Calibration of Compass During PDS"
- 2009 model year Tacoma: TSB 3023 "Initial Calibration of Compass During PDS"

NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.