Canada - Lighting - Rear License Plate Lamp Dislodged

Bulletin
2918

Issue Date
October 23, 2007

Market
Canada

Title:
REAR LICENSE PLATE LAMP RETENTION IMPROVEMENT

Component
BODY

Models
'05 - '07 Tacoma

INTRODUCTION:
During adverse driving conditions the build-up of snow, ice or mud on the rear license plate lamp housing may cause the lamp to dislodge from the rear bumper. New lamp assemblies have been developed to remedy this condition. Replace the parts in pairs only (LH + RH).

APPLICABLE VEHICLES:
- 2005 - 2007 model year Tacoma vehicles produced BEFORE the Production Change Effective VIN shown below.







PRODUCTION CHANGE INFORMATION:







PARTS INFORMATION:







WARRANTY INFORMATION:

REPAIR PROCEDURE:
Replace both License Plate Lamp Assemblies if the bulb sockets are damaged or the bulb housings are loose in the bumper assembly.

NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.