Transfer Oil

TRANSFER OIL

ADJUSTMENT




1. INSPECT TRANSFER OIL
(a) Remove the filler plug and gasket.
(b) Check that the oil level is within 5 mm (0.20 in.) of the bottom of the filler plug hole.

NOTICE:
^ When replacing the oil, recheck the oil level after driving.
^ Excessively large or small quantities of oil may cause troubles.

(c) When the oil level is too low, check for oil leakage.
(d) Tighten the filler plug with a new gasket.
Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)

2. ADJUST TRANSFER OIL
(a) Remove the filler plug and gasket then supply oil.

NOTICE:
^ When supplying oil, pour slowly.
^ Pour the oil in several stages allowing several minutes between each step.

HINT: The oil level should be within 5 mm (0.20 in.) of the bottom of the oil filler plug hole.

(b) After leaving it alone for 5 minutes, check the oil level again.
(c) Tighten the filler plug with a new gasket.
Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)