Removal and Installation

REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE:
- Some systems need to be initialized after the cable is reconnected.
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE FUEL TANK CAP
4. DISCONNECT FUEL TANK MAIN TUBE SUBASSEMBLY
5. DISCONNECT FUEL TANK RETURN TUBE
6. DISCONNECT VENT LINE HOSE
7. DISCONNECT WIRE HARNESS
8. DISCONNECT FUEL TANK TO FILLER PIPE HOSE
9. DISCONNECT NO. 1 CANISTER OUTLET HOSE
10. REMOVE FUEL TANK ASSEMBLY
11. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

INSTALLATION

1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
2. INSTALL FUEL TANK ASSEMBLY
3. CONNECT NO. 1 CANISTER OUTLET HOSE
4. CONNECT FUEL TANK TO FILLER PIPE HOSE
5. CONNECT WIRE HARNESS
6. CONNECT VENT LINE HOSE
7. CONNECT FUEL TANK RETURN TUBE
8. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
9. INSTALL FUEL TANK CAP
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected.

11. INSPECT FOR FUEL LEAK