Transmission Speed Sensor: Service and Repair
SPEED SENSORCOMPONENTS:
REMOVAL
1. REMOVE SPEED SENSOR NT
(a) Disconnect the sensor connector.
(b) Remove the bolt and sensor.
(c) Remove the O-ring from the sensor.
2. REMOVE SPEED SENSOR SP2
(a) Disconnect the sensor connector.
(b) Remove the bolt and sensor.
(c) Remove the O-ring from the sensor.
INSPECTION
Component without harness connected: (Speed Sensor NT):
1. INSPECT SPEED SENSOR NT
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the result is not as specified, replace the sensor.
Component without harness connected: (Speed Sensor SP2):
2. INSPECT SPEED SENSOR SP2
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the result is not as specified, replace the sensor.
INSTALLATION
1. INSTALL SPEED SENSOR SP2
(a) Coat a new O-ring with ATF and install it to the sensor.
(b) Install the sensor with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
(c) Connect the sensor connector.
2. INSTALL SPEED SENSOR NT
(a) Coat a new O-ring with ATF and install it to the sensor.
(b) Install the sensor with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
(c) Connect the sensor connector.