Front Seat Inner Belt Assembly

Front Seat Inner Belt Assembly:

Front Seat Inner Belt Assembly:

FRONT SEAT INNER BELT ASSEMBLY

REMOVAL

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag.

NOTE: Some systems need to be initialized after the cable is reconnected.

2. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
a. Remove the front seat.

3. REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
a. Remove the front seat.

4. REMOVE INNER FRONT SEAT CUSHION SHIELD (for Manual Seat)

5. REMOVE FRONT SEAT INNER BELT ASSEMBLY
a. Driver Side: Disconnect the 2 connectors and detach the 4 clamps.
b. Passenger Side: Disconnect the connector and detach the clamp.




c. Remove the nut and front seat inner belt.

INSTALLATION




1. INSTALL FRONT SEAT INNER BELT ASSEMBLY
a. Install the front seat inner belt with the nut.

Torque: 42 N.m (428 kgf.cm, 31 ft.lbf)

NOTE: Do not allow the anchor part of the front seat inner belt to overlap the protruding part of the front seat adjuster.

b. Driver Side:
1. Connect the 2 connectors and attach the 4 clamps.

c. Passenger Side: Connect the connector and attach the clamp.

2. INSTALL INNER FRONT SEAT CUSHION SHIELD (for Manual Seat)

3. INSTALL FRONT SEAT ASSEMBLY (for Power Seat)
a. Install the front seat.

4. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat)
a. Install the front seat.

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected.