Rear Speed Sensor

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE:
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
- Some systems need to be initialized after the cable is reconnected.

2. REMOVE REAR WHEEL
3. REMOVE REAR SPEED SENSOR LH

a. Disconnect the speed sensor connector (labeled A).
b. Remove the nut (labeled B) and speed sensor (labeled C).

4. REMOVE REAR SPEED SENSOR RH

a. Disconnect the speed sensor connector (labeled A).
b. Remove the nut (labeled B) and speed sensor (labeled C).

5. REMOVE SKID CONTROL SENSOR WIRE

a. Disconnect the sensor connector (labeled A).
b. Detach the 7 clips (labeled B).
c. Remove the bolt (labeled C).
d. Remove the nut (labeled D) and skid control sensor wire.

INSTALLATION

1. INSTALL SKID CONTROL SENSOR WIRE
a. Install the sensor clamp with the nut (labeled A).

Torque: 13 N.m (127 kgf. cm, 9 ft.lbf)

NOTE: Make sure the clamp's rotation stopper touches the installation position.

b. Install the sensor clamp with the bolt (labeled B).

Torque: 13 N.m (127 kgf. cm, 9 ft.lbf)

NOTE: When installing the clamp, do not twist the wire harness.

c. Attach the 7 clips (labeled C).

NOTE:
- When installing the clamps, do not twist the wire harness.
- When installing the clamps, securely insert them as shown in the illustration.

d. Connect the sensor connector (labeled D).

NOTE: Securely connect the connector.

2. INSTALL REAR SPEED SENSOR LH

a. Install the speed sensor (labeled A) with the nut (labeled B).

Torque: 11 N.m (107 kgf. cm, 8 ft.lbf)

b. Connect the speed sensor connector (labeled C).

NOTE: Securely connect the connector.

4. INSTALL REAR WHEEL

Torque: for Aluminum Wheel 131 N.m (1336 kgf. cm, 97 ft.lbf)
for Steel Wheel 209 N.m (2131 kgf. cm, 154 ft.lbf)

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected.

6. CHECK SPEED SENSOR SIGNAL
a. Check the speed sensor signal.