Cruise Control Switch: Service and Repair
Cruise Control Main Switch:
CRUISE CONTROL MAIN SWITCH
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE: Some systems need to be initialized after the cable is reconnected.
NOTE: After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
2. REMOVE LOWER NO.2 STEERING WHEEL COVER
3. REMOVE LOWER NO.3 STEERING WHEEL COVER
4. REMOVE STEERING PAD (w/o Steering Pad Switch)
5. REMOVE STEERING PAD (w/ Steering Pad Switch)
6. REMOVE CRUISE CONTROL MAIN SWITCH
a. Disconnect the connector.
b. Remove the 2 screws.
c. Remove the switch, as shown in the illustration.
INSTALLATION
1. INSTALL CRUISE CONTROL MAIN SWITCH
a. Install the switch, as shown in the illustration.
b. Install the 2 screws.
c. Connect the connector.
2. INSTALL STEERING PAD (w/ Steering Pad Switch)
3. INSTALL STEERING PAD (w/o Steering Pad Switch)
4. INSTALL LOWER NO.3 STEERING WHEEL COVER
5. INSTALL LOWER NO.2 STEERING WHEEL COVER
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Some systems need to be initialized after the cable is reconnected.
7. CHECK SRS WARNING LIGHT
a. Check the SRS warning light.