Oil Pressure Sender: Service and Repair
OIL PRESSURE SWITCHCOMPONENTS:
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: Some systems need to be initialized after the cable is reconnected.
2. REMOVE V-BANK COVER
3. REMOVE OIL PRESSURE SWITCH
(a) Disconnect the oil pressure switch connector.
(b) Using a 24 mm deep socket wrench, remove the oil pressure switch.
INSTALLATION
1. INSTALL OIL PRESSURE SWITCH
(a) Apply adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive: Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
(b) Using a 24 mm deep socket wrench, install the oil pressure switch.
Torque: 15 N*m (150 kgf*cm, 11 ft.*lbf)
NOTICE: Do not start the engine within 1 hour of installation.
(c) Connect the oil pressure switch connector.
2. INSTALL V-BANK COVER
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: Some systems need to be initialized after the cable is reconnected.